chore(deps): bump donglora to 1.1.0 for per-board tx_power clamping

orac/bot.py

@@ -178,8 +178,9 @@ def connect_and_run(port: str | None) -> None:
 
     boot("Connecting...")
     # `dl.connect()` auto-discovers the port, sends GET_INFO, applies
-    # RADIO_CONFIG via SET_CONFIG, and starts the keepalive daemon —
-    # no manual Ping/SetConfig/StartRx dance required.
+    # RADIO_CONFIG via SET_CONFIG (with `tx_power_dbm` auto-clamped to
+    # the device's PA ceiling — SX1262 caps at 22 dBm, SX1276 PA_BOOST
+    # at 20), and starts the keepalive daemon.
     dongle = dl.connect(port=port, timeout=2, config=RADIO_CONFIG)
     boot("Connected")
 

orac/constants.py

@@ -53,10 +53,10 @@ RADIO_CONFIG: dl.LoRaConfig = dl.LoRaConfig(
     sf=7,
     cr=dl.LoRaCodingRate.CR_4_5,
     sync_word=0x3444,
-    tx_power_dbm=22,  # DongLoRa Protocol v2 removed the "max power" sentinel; 22 dBm
-    # is the SX1262 chip ceiling and the practical upper bound on every
-    # current DongLoRa board. If you operate a board with a lower cap,
-    # lower this (or read `d.info.tx_power_max_dbm` and rebuild the config).
+    tx_power_dbm=22,  # Requested max. `connect_and_run` clamps this down to
+    # `dongle.info.tx_power_max_dbm` at connect time, so each board
+    # transmits at its own PA ceiling (SX1262: 22 dBm, SX1276 PA_BOOST:
+    # 20 dBm, …) without needing a per-board config table here.
     preamble_len=16,
     header_mode=dl.LoRaHeaderMode.EXPLICIT,
     payload_crc=True,