feat: native USB CDC-ACM support for Heltec V3

The default heltec_v3 feature now uses native USB OTG (same as V4),
appearing as /dev/ttyACM0 with the DongLoRa VID:PID (1209:5741).
This requires a hardware mod: solder R29/R3 and disconnect the CP2102
from the USB data lines.

Stock (unmodified) V3 boards should use the new heltec_v3_uart feature
which preserves the original UART-over-CP2102 behavior (/dev/ttyUSB0).

- heltec_v3: switched from UART to USB OTG
- heltec_v3_uart: new feature, UART fallback for stock boards
- Removed #[cfg] gates on UsbParts/UartParts (both always defined)
- Updated README with hardware mod instructions and board table
- Updated justfile with heltec_v3_uart board definition

src/hal/mod.rs

@@ -3,7 +3,7 @@
 //! Each submodule provides low-level bus and peripheral init for one MCU family.
 //! Board files call these with specific pins and construct higher-level drivers.
 
-#[cfg(any(feature = "heltec_v3", feature = "heltec_v4"))]
+#[cfg(any(feature = "heltec_v3", feature = "heltec_v3_uart", feature = "heltec_v4"))]
 pub mod esp32s3;
 
 #[cfg(any(feature = "rak_wisblock_4631", feature = "wio_tracker_l1"))]