feat: native USB CDC-ACM support for Heltec V3

The default heltec_v3 feature now uses native USB OTG (same as V4),
appearing as /dev/ttyACM0 with the DongLoRa VID:PID (1209:5741).
This requires a hardware mod: solder R29/R3 and disconnect the CP2102
from the USB data lines.

Stock (unmodified) V3 boards should use the new heltec_v3_uart feature
which preserves the original UART-over-CP2102 behavior (/dev/ttyUSB0).

- heltec_v3: switched from UART to USB OTG
- heltec_v3_uart: new feature, UART fallback for stock boards
- Removed #[cfg] gates on UsbParts/UartParts (both always defined)
- Updated README with hardware mod instructions and board table
- Updated justfile with heltec_v3_uart board definition

src/host/mod.rs

@@ -6,7 +6,7 @@
 pub mod framing;
 
 cfg_if::cfg_if! {
-    if #[cfg(feature = "heltec_v3")] {
+    if #[cfg(feature = "heltec_v3_uart")] {
         mod uart;
         pub use uart::host_task;
     } else {