First classic-ESP32 (non-S3) board in the firmware, and first SX127x
radio. ESP32 + SX1276 + SSD1306 OLED + AXP192 PMIC, CP2102 USB-UART
bridge. Pin map verified from MeshCore variants/lilygo_tbeam_SX1276.
The AXP192 gates power to the LoRa chip and OLED. Its I²C bus is
shared with the display, so the firmware builds I²C0 in blocking mode
first for the PMIC init, then converts the same handle to async and
hands it to the display task — avoids double-consuming the peripheral.
Lora-phy's Sx127x support drives DIO0 as the sole IRQ (SX127x has no
BUSY line); the chip runs from a crystal, tx_boost routes +20 dBm
through PA_BOOST.
The `esp-hal` / `esp-rtos` / `esp-backtrace` / `esp-println` deps have
been restructured so the chip flavour (esp32 vs esp32s3) is selected
at the per-board feature level instead of baked into the dep lines.
This keeps the existing S3 boards building on esp32s3 while the new
T-Beam feature selects classic esp32 via the same dependency set.
LoRaBoard gains supported_sf_bitmap() / supported_bw_bitmap() methods
(with SX126x defaults) so the T-Beam can report SF6–SF12 via GET_INFO
— the SX1276 has no SF5. radio_chip_id() reports 0x0011 per
donglora-protocol RadioChipId::Sx1276. freq_range_hz widens to the
SX1276 datasheet span of 137 MHz–1020 MHz.
New modules:
- src/hal/esp32.rs — classic-ESP32 MCU primitives
- src/board/esp32.rs — Sx127x radio + SSD1306 display pipe
- src/board/lilygo_tbeam.rs — the board file
- src/driver/axp.rs — AXP192 init added alongside AXP2101
ESP32-S3 + SX1262 + SH1106 OLED + AXP2101 PMIC, native USB-C.
The AXP2101 PMIC gates power to the LoRa chip and the OLED. Without
its init sequence (ALDO3 = 3.3 V for LoRa, ALDO1 = 3.3 V for OLED)
the SX1262 never responds on SPI and radio init fails.
Pin map verified against MeshCore's variants/lilygo_tbeam_supreme_SX1262.
PMIC lives on a dedicated I²C1 bus (SDA=42, SCL=41) separate from the
SH1106 on I²C0 (SDA=17, SCL=18); I²C1 is used blocking for a one-shot
init and then dropped. TCXO at 1.6 V via DIO3.
New src/driver/axp.rs holds the AXP2101 init sequence — kept minimal
(only the LoRa + OLED rails), since DongLoRa is a LoRa-over-USB bridge
and every other rail (GPS, BME280, IMU, SD, batt ADC) is out of scope.
swaits