- Added RgbLed trait with impl on () for boards without LED
- Added WS2812 driver (driver/ws2812.rs) using ESP32-S3 RMT peripheral
- 80MHz clock, 12.5ns resolution, 24-bit GRB encoding
- Zero extra crate dependencies
- Heltec V3/V3-UART/V4: WS2812B on GPIO38 via RMT channel 0
- RAK WisBlock/Wio Tracker: type LedDriver = (), led = None (no-op)
- Display task: green blink on RX packet, red blink on TX packet
- LED auto-off on timer tick (~1s), off when display is off/reset
- LoRaBoard trait gains type LedDriver: RgbLed associated type
- BoardParts gains led: Option<L> field
The default heltec_v3 feature now uses native USB OTG (same as V4),
appearing as /dev/ttyACM0 with the DongLoRa VID:PID (1209:5741).
This requires a hardware mod: solder R29/R3 and disconnect the CP2102
from the USB data lines.
Stock (unmodified) V3 boards should use the new heltec_v3_uart feature
which preserves the original UART-over-CP2102 behavior (/dev/ttyUSB0).
- heltec_v3: switched from UART to USB OTG
- heltec_v3_uart: new feature, UART fallback for stock boards
- Removed #[cfg] gates on UsbParts/UartParts (both always defined)
- Updated README with hardware mod instructions and board table
- Updated justfile with heltec_v3_uart board definition
- LoRaBoard trait now has associated types: RadioParts, CommParts, DisplayParts, DisplayDriver
- into_parts() is on the trait (enforced by compiler, not implicit convention)
- BoardParts<R, C, D> struct replaces tuple return from into_parts()
- mac_address() stays on trait, MAC also in BoardParts for convenience
- Removed mac field from DisplayParts (display task calls Board::mac_address())
- DisplayDriver associated type requires DrawTarget<Color = BinaryColor>
- Created host/ module with internal cfg dispatch (USB vs UART)
- Moved usb/task.rs → host/usb.rs, uart/task.rs → host/uart.rs
- Moved protocol_io.rs → host/framing.rs
- Renamed usb_task/uart_task to host_task (uniform name)
- Removed all host-comm cfg from main.rs
- The run() function now has ZERO board-specific conditional compilation
- Deleted old usb/, uart/, protocol_io.rs modules
- Created hal/esp32s3.rs with MCU primitives (SPI, I2C, USB, UART, timer, MAC)
- Created hal/nrf52840.rs with shared nRF boilerplate (interrupts, bus wrapping, VBUS, MAC)
- Moved SH1106 OLED driver from display/ to driver/ (clear separation from app code)
- Board esp32s3.rs now delegates MCU init to hal, keeps only peripheral wiring (RadioParts)
- nRF board files use hal for shared StaticCell patterns, mac_address, interrupt bindings
- Board files still own pin assignments and peripheral construction
- Made protocol_io.rs compile for all boards (not just heltec_v3)
- Renamed FrameAccumulator → CobsDecoder, encode_response → cobs_encode_response
- Refactored USB task to use shared CobsDecoder and route_command from protocol_io
- Removed ~80 lines of duplicated COBS framing and command routing from usb/task.rs
- Single canonical MAX_FRAME definition in protocol_io.rs
swaits