feat(boards): LilyGo T-Beam S3 Supreme support

ESP32-S3 + SX1262 + SH1106 OLED + AXP2101 PMIC, native USB-C.

The AXP2101 PMIC gates power to the LoRa chip and the OLED. Without
its init sequence (ALDO3 = 3.3 V for LoRa, ALDO1 = 3.3 V for OLED)
the SX1262 never responds on SPI and radio init fails.

Pin map verified against MeshCore's variants/lilygo_tbeam_supreme_SX1262.
PMIC lives on a dedicated I²C1 bus (SDA=42, SCL=41) separate from the
SH1106 on I²C0 (SDA=17, SCL=18); I²C1 is used blocking for a one-shot
init and then dropped. TCXO at 1.6 V via DIO3.

New src/driver/axp.rs holds the AXP2101 init sequence — kept minimal
(only the LoRa + OLED rails), since DongLoRa is a LoRa-over-USB bridge
and every other rail (GPS, BME280, IMU, SD, batt ADC) is out of scope.

src/main.rs

@@ -48,7 +48,7 @@ cfg_if::cfg_if! {
     if #[cfg(any(feature = "rak_wisblock_4631", feature = "wio_tracker_l1", feature = "waveshare_rp2040_lora"))] {
         use defmt_rtt as _;
         use panic_probe as _;
-    } else if #[cfg(any(feature = "heltec_v3", feature = "heltec_v3_uart", feature = "heltec_v4", feature = "elecrow_thinknode_m2"))] {
+    } else if #[cfg(any(feature = "heltec_v3", feature = "heltec_v3_uart", feature = "heltec_v4", feature = "elecrow_thinknode_m2", feature = "lilygo_tbeam_supreme"))] {
         use esp_backtrace as _;
         use esp_println as _;
     }
@@ -72,7 +72,7 @@ cfg_if::cfg_if! {
         async fn main(spawner: Spawner) {
             run(spawner).await;
         }
-    } else if #[cfg(any(feature = "heltec_v3", feature = "heltec_v3_uart", feature = "heltec_v4", feature = "elecrow_thinknode_m2"))] {
+    } else if #[cfg(any(feature = "heltec_v3", feature = "heltec_v3_uart", feature = "heltec_v4", feature = "elecrow_thinknode_m2", feature = "lilygo_tbeam_supreme"))] {
         #[esp_rtos::main]
         async fn main(spawner: Spawner) {
             run(spawner).await;