feat(boards): LilyGo T-Beam S3 Supreme support

ESP32-S3 + SX1262 + SH1106 OLED + AXP2101 PMIC, native USB-C.

The AXP2101 PMIC gates power to the LoRa chip and the OLED. Without
its init sequence (ALDO3 = 3.3 V for LoRa, ALDO1 = 3.3 V for OLED)
the SX1262 never responds on SPI and radio init fails.

Pin map verified against MeshCore's variants/lilygo_tbeam_supreme_SX1262.
PMIC lives on a dedicated I²C1 bus (SDA=42, SCL=41) separate from the
SH1106 on I²C0 (SDA=17, SCL=18); I²C1 is used blocking for a one-shot
init and then dropped. TCXO at 1.6 V via DIO3.

New src/driver/axp.rs holds the AXP2101 init sequence — kept minimal
(only the LoRa + OLED rails), since DongLoRa is a LoRa-over-USB bridge
and every other rail (GPS, BME280, IMU, SD, batt ADC) is out of scope.

README.md

@@ -24,6 +24,7 @@ All commands are run from the `firmware/` directory.
 | Heltec V3 (UART) | `heltec_v3_uart` | ESP32-S3 | SX1262 | CP2102 bridge | xtensa-esp32s3-none-elf |
 | Heltec V4 | `heltec_v4` | ESP32-S3 | SX1262 | Native CDC-ACM | xtensa-esp32s3-none-elf |
 | ELECROW ThinkNode-M2 | `elecrow_thinknode_m2` | ESP32-S3 | SX1262 | CP2102 bridge | xtensa-esp32s3-none-elf |
+| LilyGo T-Beam S3 Supreme | `lilygo_tbeam_supreme` | ESP32-S3 | SX1262 | Native CDC-ACM | xtensa-esp32s3-none-elf |
 | RAK WisBlock 4631 | `rak_wisblock_4631` | nRF52840 | SX1262 | Native CDC-ACM | thumbv7em-none-eabihf |
 | Waveshare RP2040-LoRa | `waveshare_rp2040_lora` | RP2040 | SX1262 | Native CDC-ACM | thumbv6m-none-eabi |
 | Wio Tracker L1 | `wio_tracker_l1` | nRF52840 | SX1262 | Native CDC-ACM | thumbv7em-none-eabihf |